What's For Supper?

Discussion in 'Food & Drinks' started by Sheldon Scott, Sep 11, 2015.

  1. Hedi Mitchell

    Hedi Mitchell Supreme Member
    Registered

    Joined:
    Mar 18, 2017
    Messages:
    9,419
    Likes Received:
    16,564
    John.on the baking powder...would not use but a half tablespoon.
     
    #3106
    John Brunner likes this.
  2. John Brunner

    John Brunner Senior Staff
    Staff Member Senior Staff Greeter Task Force Registered

    Joined:
    May 29, 2020
    Messages:
    25,154
    Likes Received:
    36,892
    Well, THAT was disgusting.

    I seasoned the meat and let it come to room temp.
    I dredged it in seasoned flour, then egg, then seasoned flour.
    I fried it for about 4 minutes on each side.
    I put it in a 350' oven for 25 minutes, covered in foil.

    It was flavorless, the breading slid off in one intact piece, and the meat was horribly tough. I'm sure I've made something this bad before, but if I have, I can't recall what it might have been.
     
    #3107
    Yvonne Smith likes this.
  3. Beth Gallagher

    Beth Gallagher Supreme Member
    Registered

    Joined:
    Jan 11, 2018
    Messages:
    21,978
    Likes Received:
    46,871
    Did you use cube steak or cutlets? I've never put mine in the oven after frying so I don't know how Gloria does that... but I "assume" that covering with foil would hold in moisture and soften the crunchy breaded coating.
     
    #3108
  4. John Brunner

    John Brunner Senior Staff
    Staff Member Senior Staff Greeter Task Force Registered

    Joined:
    May 29, 2020
    Messages:
    25,154
    Likes Received:
    36,892
    I used cube steak. It was pretty thick...about 5.5 oz each and like a thick burger.

    When I've seen this in diners (and I've only tried it once), the finished product has been pretty thin. Except the diner one almost seemed as though bits of beef had been stirred into the breading and a patty has been made of it...I did not see a distinguishable layer of meat in the middle.

    If I tried it again (and I doubt that I will), I'd find a recipe that uses a different cut of meat that that I would beat into a sheet of paper myself with a tenderizing mallet.
     
    #3109
    Beth Gallagher likes this.
  5. Beth Gallagher

    Beth Gallagher Supreme Member
    Registered

    Joined:
    Jan 11, 2018
    Messages:
    21,978
    Likes Received:
    46,871
    I prefer very thin cutlets, so "like a thick burger" sounds too thick to me. I have used round steak many times that I tenderize myself by beating it very thin with the tenderizing mallet. Sorry it didn't turn out well. If you have leftovers, make gravy and put the leftover meat in it; simmer covered for a while until it gets more tender. Serve over rice or noodles.
     
    #3110
  6. John Brunner

    John Brunner Senior Staff
    Staff Member Senior Staff Greeter Task Force Registered

    Joined:
    May 29, 2020
    Messages:
    25,154
    Likes Received:
    36,892
    I made plenty of cream gravy. This is not gonna get more tender. It was tough to hack through with a steak knife, as though it were full of gristle. I am at one of those "I never throw food away" moral crossroads. Maybe I could chop it up or run it through a food processor and serve with noodles as you suggested. Maybe I'll make some homemade egg noodles to take the edge off of the disappointment. Or maybe this once I'll take the low road. I could chuck it into the woods for the critters....
     
    #3111
  7. Beth Gallagher

    Beth Gallagher Supreme Member
    Registered

    Joined:
    Jan 11, 2018
    Messages:
    21,978
    Likes Received:
    46,871
    Just toss it and chalk it up to experience. :D
     
    #3112
  8. John Brunner

    John Brunner Senior Staff
    Staff Member Senior Staff Greeter Task Force Registered

    Joined:
    May 29, 2020
    Messages:
    25,154
    Likes Received:
    36,892
    Yup.

    Thanks for the thumb on the scale ;)
     
    #3113
  9. Hedi Mitchell

    Hedi Mitchell Supreme Member
    Registered

    Joined:
    Mar 18, 2017
    Messages:
    9,419
    Likes Received:
    16,564
    @John Brunner
    I am so sorry yours did not turn out good. I have never had any problems.
    Maybe it was the meat itself. Just can't imagine what could of gone wrong.
    Very disappointing I know.
     
    #3114
    John Brunner likes this.
  10. John Brunner

    John Brunner Senior Staff
    Staff Member Senior Staff Greeter Task Force Registered

    Joined:
    May 29, 2020
    Messages:
    25,154
    Likes Received:
    36,892
    Thanks, Gloria.

    You're right on one level...the meat was not the best. But I've never cooked with cube steak before, so had no idea what I was looking at. When I opened the pack of the 4 patties, the non-visible sides of the meat had started turning...and it had 4 days to go before the Use By Date. Still doesn't explain the toughness. I know I under-cooked it in the pan because the recipes I looked at said to do 4 minutes per side for 1/4# pieces, and while I did cook for 4 minutes, mine weighed more than 1/4#.

    Other than the emotional trauma of wasting food, it's no big deal. And I still got my belly full. It's certainly not the first (or worst) cooking failure I've ever had, and likely won't be the last. That's the risk you take when you go beyond boiling water and opening cans, huh?
     
    #3115
    Last edited: Dec 16, 2020
  11. Hedi Mitchell

    Hedi Mitchell Supreme Member
    Registered

    Joined:
    Mar 18, 2017
    Messages:
    9,419
    Likes Received:
    16,564
    Perhaps the meat was too thick for this method of cooking. The cube steaks I buy are not thick but not real thin. My hubby has been meatcutter for over 20 years and he has told me before... The way meat is cut and where it comes from plays part meat being tender. Especially the cut.
     
    #3116
    John Brunner likes this.
  12. John Brunner

    John Brunner Senior Staff
    Staff Member Senior Staff Greeter Task Force Registered

    Joined:
    May 29, 2020
    Messages:
    25,154
    Likes Received:
    36,892
    I agree with you and with your husband.

    The funny thing about the thickness was that the highly-rated recipe I found called for 1/4# cube steak patties per serving. I blindly went with it without even thinking about what I was gonna be making with it. I should easily have been less than 1/2 that. Or maybe I could have hammered it flat.

    Regarding quality: I used to travel to Lenexa, Kansas with work. Hands-down the local beef was the best I ever had. There's nothing like a great steak for lunch.

    Bottom line is that for me it's not that big of a deal. When I read your comment, CFS sounded like a nice change and something I've never made before (and have only eaten once.) I might try it again just so I don't let a recipe get the better of me.

    By the way: you mentioned baking soda. I assume that gets mixed in with the flour. You know, I've been aware of tenderizing meats this way, but I have never tried it.
     
    #3117
  13. Beth Gallagher

    Beth Gallagher Supreme Member
    Registered

    Joined:
    Jan 11, 2018
    Messages:
    21,978
    Likes Received:
    46,871
    I'm thawing chicken tenders and I'm thinking I'll "create" something with them and that Cream of Poblano soup and serve it over rice or noodles. This should be interesting. :D
     
    #3118
  14. John Brunner

    John Brunner Senior Staff
    Staff Member Senior Staff Greeter Task Force Registered

    Joined:
    May 29, 2020
    Messages:
    25,154
    Likes Received:
    36,892
    Your personal take on a well-known restaurant: Loco Pollo
     
    #3119
    Beth Gallagher likes this.
  15. Beth Gallagher

    Beth Gallagher Supreme Member
    Registered

    Joined:
    Jan 11, 2018
    Messages:
    21,978
    Likes Received:
    46,871
    I wish I had a fresh poblano pepper or two in the house; that would definitely step this experiment up a bit. Hmmm, I have some corn tortillas; maybe a type of enchilada dish with a bunch of cheese. thinkin.gif
     
    #3120
    Hedi Mitchell likes this.

Share This Page